Anaerobic adhesives

How do anaerobic adhesives work? They work on the principle of cutting off the air, where the activator-reactor are iron particles - in their absence, an additional activator is used (description of its use below). in terms of the gap that we have in the connection and one of the 3 strength classes, that is: 1 - easily disassembled - screw the threads to unscrew them later - use to seal, cut off corrosion and prevent self-unscrewing. 2 - medium disassembled - to unscrew you need a wrench and a little force, use as in the first point, but with greater forces, especially in bolts above M8-M10.3 - difficult to disassemble - used to protect against unscrewing without the possibility of disassembling later - with small screws it can even happen sprains. What connections do we use for? threaded surfaces such as bolts, nuts, pipe threads and hydraulic belt joints such as gluing bearings and sleeves sealing flat surfaces all the above with minimal play up to approx. 0.3 mm. How do anaerobic adhesives work? protect against unscrewing (new and slightly worn ones, they seal against various media, such as water, oils, greases, technical gases (except strongly oxidizing media) distribute the forces over the entire surface even with less fitting elements which prevents further deformation protects against corrosion allows you to tighten even slightly loose threads and twisted Use of activator for anaerobic adhesives We use to raise the maximum gap by about 0.1 mm than the intended version If one or both sides of the metal has little or no iron content, e.g. aluminum or stainless steel If we want to accelerate the bonding speed Which thread glue red or blue? Manufacturers, in order to recognize the strength of a given glue, dye it in different colors and the most common color versions are red as hard-disassembled and blue as medium-disassembled. How to fix zeros important thread in aluminum or steel? This is a very common case that occurs in automotive workshops and maintenance departments, therefore we have introduced a kit that allows you to repair broken threads. It consists of two adhesives: an anaerobic adhesive and liquid metal for large gaps.