Thread adhesive KEMISKOL V653 10g

Strong thread adhesive, i.e. the third class of disassembly, with an additional increased temperature of up to 200 degrees. Application as an adhesive: for sealing threads, repairing a worked thread - as an adhesive for broken threads, broken threads - partially or fully (it is worth using ACTIVATOR 11 to increase the gap or use the thick version T674), used nuts, we replace anti-unscrewing washers, and other thread, belt and sleeve connections, gluing bearings with larger gaps Technical data: Shear strength (N / mm²): 30 ≤ 35 Breakaway torque (Nm): 40 ≤ 50 Viscosity (cPS): 800 ≤ 850 Maximum gap (mm ): 0.20 Temperature range (° C): -60 ≤+200 Fastening class: 3 Packaging: 10 g (50 g and 250 g on request) Fastening classes in anaerobic adhesives: 1 - thread sealing and fastening with subsequent easy unscrewing (allows to seal and / or fastenings against self-loosening of nuts, bolts and pipes due to vibrations and impacts 2 - the same as point 1, but we use a wrench to unscrew and the thread is quite resistant, 3 - As point: 1 and 2, however, the mount is there so strong that in many cases it is impossible to unscrew, the screw may be damaged and / or it is necessary to heat the thread surface to "burn" the glue. We also use this class for gluing bearings, belt, toothed and sleeve surfaces. If you have: - a bolt or a nut that you tighten before unscrewing and sealing, choose V032 or T333 - bolt / nut gluing "permanently" V653 / T674 - bearings and bushings - small gap V640, larger slack V653 - pipe threads T138 or permanently T674 - In the case of a larger gap than the maximum used or acceleration of bonding with copper, brass, bronze and stainless steel, we use ACTIVATOR 11 for one surface 0.1 mm by two to 0.15 mm. Our advice, in words, in writing and through experience, is the best of our knowledge, but only non-binding guidelines are relevant, also with regard to any third party property rights, and does not exempt you from your own trials of the products we supply with regard to their suitability for certain technology and goals. We ensure, of course, the absolute quality of our products according to the general terms of sale and delivery. KEMISPLUS - Manufacturer of adhesives for industry for over 30 years. He has developed and continues to improve his 3 main brands KemisKOL, (anaerobic adhesives) KemisKIT, and KemisPOX, (epoxy adhesives). All production is carried out in Slovenia.