Adhesive for bearings KEMISKOL V640 10g

Anaerobic Adhesive for Bearings KEMISKOL V640 A special, very rare version of the anaerobic adhesive with the highest strength for small gaps and mating surfaces such as mounting bearings or screwing threads into M8 and fine threads. Version with increased temperature resistance up to 180 degrees and class 3 disassembly, which, as a rule, can only be unscrewed after heating. If the bearing has 0.1-0.2mm clearances (so-called specifically loose - after inserting you can move it slightly to the sides), use the KEMISKOL V653 version. Technical data: Shear strength (N / mm²): 30 ≤ 35 Breakaway torque (Nm): 40 ≤ 50 Viscosity (cPS): 20 ≤ 45 Maximum gap (mm): 0.05 Temperature range (° C): -60 ≤+180 Fastening class: 3 Packaging: 10g (50g and 250g on request) Fastening classes in anaerobic adhesives: 1 - thread sealing and fastening with subsequent easy unscrewing (allows to seal and / or fastenings against self-loosening of nuts, bolts and pipes under the influence of vibrations and impacts 2 - the same as point 1, but we already use a wrench to unscrew and the thread is quite resistant, 3 - As points 1 and 2, but the fastening is so strong that in many cases it is not possible to unscrew , the screw may be damaged and / or it is necessary to heat the thread surface to "burn" the glue. We also use this class for gluing bearings, belt, toothed and sleeve surfaces. If you have: or T333 - screw / nut glued e "fixed" V653 / T674 - bearings and bushings - small gap V640, larger clearance V653 - pipe threads T138 or fixed T674 - In case of a larger gap than the maximum used or faster bonding with copper, brass, bronze and stainless steel, we use ACTIVATOR 11 on one face 0.1mm by two to 0.15mm. Our advice, in words, in writing and through experience, is the best of our knowledge, but only non-binding guidelines are relevant, also with regard to any third party property rights, and does not exempt you from your own trials of the products we supply with regard to their suitability for certain technology and goals. We ensure, of course, the absolute quality of our products according to the general terms of sale and delivery. KEMISPLUS - Manufacturer of adhesives for industry for over 30 years. He has developed and continues to improve his 3 main brands KemisKOL, (anaerobic adhesives) KemisKIT, and KemisPOX, (epoxy adhesives). All production is carried out in Slovenia.