Adhesive for conveyor belts ATK 901

Reliable bonding of conveyor and transport belts made of rubber and rubber-like materials. A proven product in production, regeneration and repair. It gives a permanently elastic joint resistant to water, chemicals and other solutions. During the use of conveyor belts, the natural wear of the surface progresses faster in some places and then the surface can be repaired. If we want to insert a piece of new tape, we will also do the job. The glue itself, when properly applied, gives a force equal to or greater than the bonded surface. The material should be torn during the bonding test. The most common cases of gluing and choosing the right product: gluing raw and reinforced rubbers - ATK 901 (if silicone then Atkfix06+ primer) connecting transmission belts - flat, wedge, toothed and other rubber belts - ATK FIX or ATK 901 gluing rubbers to drums and linings - ATK 901 with metal underlay and minor repairs several centimeters long atkfix 06 drive, transmission and PU belts, pvc, pa and others - ATK PU 1/5/9 or atk fix 60 if you have mesh conveyor belts use this combination of rubber+ felt, cork, lining, material / fabric - we use U800 also with foamed EPDM belts and drive lines made of elastomers, in most cases we glue atkfix 06+ primer We glue various types of belts: rubber conveyor belts rubber-material / fabric conveyor belts conveyor belts made of rubber-like materials, also reinforced with metal, bonding of scrapers, wedges, guides and profiles for repairs of transport belts - ro rips, cracks production of new types of repairs: production of new ones - overlap repair of tears and cuts - gluing patches, regeneration of abrasions and holes, gluing side reinforcements, guides, scrapers, velkants and wedges. Glued materials: raw rubber rubber reinforced with fabrics, belts and fibers rubber for metal mesh reinforcement pvc belts Properties: resistance to fresh and salt water, gasoline, oils and other petroleum derivative chemicals flexible joint Instructions for joining the conveyor belt 0. mix the base first and then remove as much as use up and mix thoroughly with the reactor. 1. sand the excess rubber on each side of the belt so that after gluing you get an even surface 2. the overlap should be from 5 to 15 cm, depending on the belt width. 3.Apply glue on two surfaces and wait for 10-15 minutes to dry. 4.Apply it again and wait another 5 minutes. 5. connect the surfaces with each other by pressing with a roller, applying pressure or placing under the press for the first minutes 6. full strength occurs after 24 hours. Conveyor belt repair instructions, such as tear-crack-cut and abrasion, first mix the base and then remove as much as you use and mix thoroughly with the reactor. sand the surface to about 2-5 cm more than the crack and the thickness of the patch you will be gluing if, after gluing, you want to get a surface equal to the native fabric, cut the patch, continue as above from point 3. Sand the excess patch or cut off to an even surface . Optional: Small package: 200 g (base) 9 g of hardener Large package: 750 g (base), 39 g of hardener Remember: if you are not sure about the quality and composition of the rubber, do some trial tests on the redundant piece - the strength of the rubber should always be grinded in the place of gluing and degreased from dirt, dust and loose pieces. mix the product well - first the base (large can), then add the reactor