Adhesive for rubber, plastic and aluminum ATK PU16

ATK PU16 adhesive for hard rubbers with other materials such as metal, plastics, composites, glass, etc. Due to the fact that it is a two-component, solvent-free product, it can be applied over the entire surface and pressed immediately - no need to wait for evaporation. We glue rubber to: metal rubber, e.g. aluminum, steel, copper, brass wood, plywood, chipboard / fiberglass (using AP3 we increase the bond strength) plastic (for pp, pp / epd, m, tpo, tpe, teo) ATK 822 primer surface) other materials after previous tests also with the use of ATK 822 primer, which increases adhesion to many substrates, especially loose, "old" and absorbent ones. In the case of hard-elastic rubber, use this set. Instructions: clean the glued surface with a degreaser and roughen it with sandpaper, if the substrate requires it, use ATK 10 or P200 primer and wait for evaporation / drying, apply the glue in a straight line or on the entire surface and press down (no strong pressure or press is required, as with contact adhesives or cyanoacrylate) in the places of cavities, gaps, apply a thick glue so that it fills the free space, wait until fully bonded. Remember: - when gluing, you get a fairly hard connection, so if the rubber is very flexible, use ATK U-800. Of course, the glue itself will stick it together, but there will be a difference between the hardness. Of course, when gluing to rigid materials such as metal or plastic, it will not matter much. Technical data: Opening time: 3-4 min. Initial setting: 15 minutes (full 8h.) Viscosity: 60,000 cPs Elongation: 20% Tensile strength: up to 22 N / mm2 Hardness: 70D By purchasing this set you get: 1. Rubber glue ATK PU 16 BLK LV 50 ml 2. Mixer - 1 piece (05-16) 3. Isopropanol-based degreaser - 100 ml 4. ATK 10 - 5 ml adhesion increasing primer 5. Squeezer for 50 ml cartridges. 1: 1 Want a bigger package? - choose a product with a longer time to apply ATK PU021