Methacrylate adhesive for PP, PE, PTFE - Acralock PP 1-02

Adhesive for Acralock 1-02 type PP and PE, etc., i.e. polyethylene, polypropylene, ptfe and polyacetal. Earlier generations of glue sold under the name MEGA 99 - PP5 The glue is characterized by high resistance to chemical compounds, full resistance to water. An important element is the fact that you do not need to use any primers or primers. Our tests show that it is currently the best adhesive of this type on the market, surpassing other methacrylic, epoxy and cyanoacrylate adhesives when joining difficult-to-bond materials. The glue is suitable for gluing two surfaces, so if you want to glue a crack, for example, stick a piece of another plastic or metal overlay. If you want to glue very small surfaces such as hooks, handles, etc., and you do not want to glue the reinforcements, use ATK FIX with a primer. Adhesives hard-to-glue materials: PP (polypropylene) PE (PEHD, HDPE, hard) PELD (LDPE) POM TPO, TEO PTFE - (e.g. Teflon) new generation materials such as: PEI, PEEK, PES, PVDF, TCF, PCF, PBI, PAI, PPS-U, PS-U, PFA, ECTFE, metals composites other plastics such as PA, PET, ABS, PVC, PMMA, PU See also adhesive tests with Acralock PP-1-02: Bonding polypropylene PP Bonding polyethylene PE Teflon bonding with PTFE Technical data: working time: 2-3 min. initial setting: 180 min. (full 24h) shore hardness D: 75 working temperature: -55-85 degrees (1h. - 150) resistance to weather conditions, water, oil, grease etc. optimal gap: 0.5-4mm cartridge: 50 ml. Remember: In the case of temperatures above 18 C, in order to maintain the best properties - we send the glue in a special refrigerated cartridge. The glue should be stored in the refrigerator and should not be more than 2 hours out of it. It is only shipped from Monday to Thursday. 1: 1 glue in a cartridge - a squeezer is needed (the glue cannot be mixed by hand). The set with the glue includes one stirrer (mixer). We recommend using 2-3 agitators per one pack of glue. Difficult-to-bond plastics - which products should be used in appropriate situations: - general pp, pe, pom, ptfe bonding butt and overlapping or at cracks by bonding the PP 1-02 reinforcement, e.g. a broken plastic barrel - bonding small ATK FIX elements with a primer - pp bonding , pe, pom and ptfe - bonding polyethylene foams - U-800i 812 with ATK823 primer or warm ATK113 - bonding lamps and bumpers made of pp, pp / epdm, pp+ .... pu16 with 822 lining - bonding and sealing surfaces with pp ATK 812+ 822, pe ATK 812+ 823 (or see point 1) - all kinds of PE foils - insulation, geomembranes, roofing membranes use HYLKOL Our word, writing and experience advice results from our best knowledge, however, they are only valid non-binding guidelines, also with regard to any third party property rights and do not exempt you from your own trials of the products we provide, in terms of their suitability for specific technologies and elow. We ensure, of course, the absolute quality of our products according to the general terms of sale and delivery. If you are a manufacturer and need larger amounts of glue - we will perform free tests. Make an appointment with our technologist!