Transparent glass and metal adhesive ATK UV35

The set with a high-density UV glass glue, which allows us to glue less folded surfaces, e.g. glass and metals, for bonding: - glass with glass - glass with metals: stainless steel, aluminum, "ordinary" steel The recommended adhesive is ATK UV35 due to increased resistance to moisture and water. Application: Clean two surfaces with a degreaser from the kit, if necessary, heat up, apply the glue and press the surfaces, if you want to remove the flashing, you can do it right away or wait for the initial hardening of the glue until it is soft and then cut off the excess, light the surface in the places of gluing, sticky Clean the surface with a degreaser from the set Included in the kit: 1. UV glue for glass with metal ATK UV 35 - 50 ml 2. Degreaser based on isopropylene 100 ml 3. Flashlight 2W Remember: - use thick gloves so as not to cut, - the surface must be clean and dry; if you want to glue the surfaces below 20 degrees, heat the glued surfaces to raise the temperature and remove residual moisture, - remember to do the test on an unnecessary piece of the exposure length beforehand, - if you will glue the surfaces vertically, you can use the dense version: ATK UV 22 - In case of insufficient strength for metal we use the AP1 etchant