Description
Dictionaries
Comments
Steel plasticine for repairing leaks in METALFIX pipes Steel or aluminum mass in the form of plasticine for repairing leaking metals, also for bonding under water. Used as a standalone product or in combination with FE21, AL21 and MED21 liquid metals. After gluing, the surface can be ground, drilled, threaded, milled and even painted. Specialist epoxy mass for repair and sealing is available in 2 varieties as a plasticine stick: for repairing steel - 120 g (steel, cast iron, wood, ceramics, stone, concrete) for repairing aluminum - 120 g (aluminum, copper, brass, bronze, wood , stone, ceramics, concrete) Key features: The product is available in the form of a kneading mass - in the form of plasticine. continuous work temperature from -40 to+200 degrees, and short-term up to 300 ° C Resistant to moisture, chemicals Color similar to aluminum or steel After 1.5 h the product is hardened, complete chemical hardening is 7 days Ideal for: installation pipes , fuel tanks, other metal tanks, cracks, where an abrasion-resistant seal is necessary, thanks to appropriately selected components, spark fillers with mechanical grinding stone treatment. aluminum and cast iron steel pipes, copper repair of casting defects cracked engines, bodies and casings of cracked oil pans, broken bearing seats repair of cavitation defects regeneration of corroded surfaces regeneration of formed threads What can we do? we fill the cavities, restore the missing elements, remove the leaks, seal the holes, level the surface Specifications: continuous operation temperature from -40 to+200 degrees, and short-term operation even up to 300 ° C Curing time: 20-30 minutes Full mechanical strength: 24 hours Full chemical resistance: 7 days Resistance: to water, chemicals such as gasoline, oils, greases Instructions, if you use it yourself: - clean the surface to the raw metal by rubbing with sandpaper, a brush, etc. - if you glue dry, degrease IPA or acetone - prepare the mass by cutting off a piece and kneading to a uniform color (remember about gloves) - in the case of pressure - the leaking surface, press firmly on the surface and apply pressure, e.g. from a half-tube, sheet metal, plastic cover with foil so that the element does not stick - the pressure can be pulled with bands, carpentry clamps or pressed with a spreader 1-2h. remove the fasteners and sand the surface so that there are no burrs, etc. If the leak has been blocked and you have the possibility of further dry work, you can apply the KEMISPOX FE21, AL21 or MED21 compound on the surface, however, it is recommended to stick the insert - sheets 3-5 cm wider than the crack above glue or apply EP61 glue on the same principle. The second application is the initial filling of cavities before gluing with kemispox, especially if we do not have to reach from both sides, press the mass to be kneaded into the groove - the slant that we previously made to the height of 3/4 of the wall and leave to bind for 1-2 hours. then we apply the fe21 / al21 mass as described on the product. Thanks to plasticine, we prevent the liquid metal from being pressed inside during the filling of the surface.
Comments