Epoxy metal adhesive EP61

Epoxy Structural Adhesive for metals and composites ATK EP 61 Need a large package? - go here Two-component structural adhesive based on modified epoxy for bonding metals, composites, stones and selected materials. The minimum thickness of the glue between the surfaces is controlled by distance balls with a diameter of 0.2-0.3 mm, which do not allow all the glue to be squeezed out even when pressed with a press or sheet metal clamps, which has a direct impact on the optimal strength of the glue. We can glue: ferrous and non-ferrous metals, including: steel, stainless steel, raw and anodized aluminum, copper, brass, bronze and other metal alloys wood, stone and glass plastic - after previous strength tests We glue two separate surfaces, in case of gluing cracks, holes we glue a piece of the same material. Information: Mixing ratio by volume: 2: 1 Mixing ratio by weight: 1.9: 1 Specific gravity g / ml: 1.1 Odor: slight amine odor. Color: black. Open time: 60 minutes at 20 degrees. Hand strength: 3-5 hours. (approx. 1mpa) Full strength: 24h Features: resistance to powder coating can be spot-welded before the adhesive hardening anti-corrosion protection at the bonding point high resistance to vibrations and impacts due to the form of a thick paste it is possible to apply on vertical and ceiling surfaces Available packages: 50 ml cartridge+ 2 mixers complete for mixing the glue. 195 ml cartridge+ 2 mixers included for mixing the glue. NOTE: The times given can be significantly shortened by heating the adhesive / surfaces after application to 60 degrees for 30 minutes. - time reduction by approx. 30%, up to 90 degrees for 1h to 80%. (do not exceed 120 degrees) Physical properties and more information can be found in the technical sheet. Check also our glass adhesives. Our advice, in words, in writing and through experience, is the best of our knowledge, but only non-binding guidelines are relevant, also with regard to any third party property rights, and does not exempt you from your own trials of the products we supply with regard to their suitability for certain technology and goals. We ensure, of course, the absolute quality of our products according to the general terms of sale and delivery. If you are a manufacturer and need larger amounts of glue - we will perform free tests. Make an appointment with our technologist for a free visit!