Two-component steel adhesive ATK EP61

Two-component steel adhesive - epoxy ATK EP 61 Two-component structural adhesive based on modified epoxy for bonding metals, composites, stones and selected materials. The minimum thickness of the glue between the surfaces is controlled by distance balls with a diameter of 0.2-0.3 mm, which do not allow all the glue to be squeezed out even when pressed with a press or sheet metal clamps, which has a direct impact on the optimal strength of the glue. Information: Mixing ratio by volume: 2: 1 Mixing ratio by weight: 1.9: 1 Specific gravity g / ml: 1.1 Odor: slight amine odor. Opening time: 60 minutes at 20 degrees. Hand strength: 3-5 hours. (approx. 1mpa) Full strength: 24h Features: resistance to powder coating can be spot-welded before the adhesive hardening anticorrosive protection at the bonding point high resistance to vibrations and impacts thanks to the form of a thick paste it is possible to apply on vertical and ceiling surfaces The set includes: 1. ATK EP 61 glue (50 ml cartridge)+ 2 mixers (mixers) for mixing the glue (05-24) 2. Squeezer for glues 1: 1 3. Degreaser 250 ml based on isopropanol Package 190 ml (only on request) NOTE: Specified times can be significantly reduced by heating the adhesive / surfaces after application to 60 degrees for 30 minutes. - time reduction by approx. 30%, up to 90 degrees for 1h to 80%. (do not exceed 120 degrees) Physical properties and more information can be found in the technical sheet.