Description
Dictionaries
Comments
Glue for metal letters - stonework - ATK PU 16 It allows you to quickly stick letters made of brass, bronze and stainless steel on the facade, tombstones and other stones. The reliability of the glue is so great that there is no problem with durability, and at the same time, if you try to tear-off or unstick the letter, it will not damage the stone-marble, etc. We glue letters made of metal: brass bronze stainless steel raw and anodized aluminum to stone substrates: marble granite stoneware field stone other natural stones You can also glue: letters for the monument photos metal cross for the monument Application: 1. Degrease the surface 2. Rub the metal surface with sandpaper 3. If any old glue remains on the surface, it should be completely removed by cutting and sanding because if we stick to the old glue, there may be a situation where the old glue falls off after the previous glue detaches. , 4. Put glue on the cartridge and squeeze it so that the two ingredients come out next to each other, 5. Put on the mixer and feed 1 cm of glue - you have 3-4 minutes. to apply the glue, 6. Apply to the letter so that after pressing the glue spreads on the surface and press lightly to leave 0.5-1 mm of glue between the surfaces 7. Stick the paper tape so that the letter does not slip off (after approx. 30 minutes - 1h you can remove the fixing) 8. If the glue came out on the sides, you can gently cut off the excess glue. Note: - the best effect is obtained when gluing at positive temperatures, because below 5 degrees moisture / dew may occur. If possible, heat the bonding point beforehand. Technical data: Opening time: 3-4 minutes Initial setting: 15 minutes / 30 minutes (full 8 hours) Viscosity: 60,000 cPs Elongation: 50% Shear strength: 23 N / mm2 Hardness: 65D Included: ATK PU16 BLK LV polyurethane adhesive - 50 ml+ 1 mixer Degreaser for isopropanol base - for proper cleaning before gluing - 100 ml Glue squeezer 1: 1 Packaging: 1: 1 cartridge 50 ml. (in the set you get 2 mixers / stirrers - 05-16) Do you want a bigger package? - choose a product with a longer application time. ATK PU021 ATK PU 5/9/16 SERIES - these are pure polyurethanes of the new generation MDI+ polyolio without ordinary isocyanates (they harden quickly on contact with air and a very small decrease in strength with time), therefore they are used in industry replacing the old generation PU. Our advice, in words, in writing and through experience, is the best of our knowledge, but only non-binding guidelines are relevant, also with regard to any third party property rights, and does not exempt you from your own trials of the products we supply with regard to their suitability for certain technology and goals. We ensure, of course, the absolute quality of our products according to the general terms of sale and delivery. If you are a manufacturer and need larger amounts of glue - we will perform free tests. Make an appointment with our technologist for a free visit!
Comments