Adhesive for the regeneration of FE21 steel tanks

Metal adhesive, for the regeneration and repair of steel tanks. If the tank comes into contact with food, you can choose the AL21 version with a drinking water certificate. You can repair with steel glue: - fuel tank - silos - pipes - barrels (regeneration of steel barrels - after cracks and holes) - sealing assembly, inspection, technological holes etc. in places: - small holes and abrasions - larger holes (more than 2-3 cm. recommended insertion or sticking of a piece of metal) - surfaces corroded by rusts or chemically Repair: - clean the surfaces with sandpaper for 3-5 cm more than the damage - wash with a degreaser from the set - etch the surfaces AP1 and wait approx. 15 minutes. (it's a good idea to slightly heat up the surface) - mix the glue in the right proportion - apply rubbing well so as not to leave air between the layers - after 2-3 layers you can flood the mesh, it will be easier for you to achieve the required min 2-3mm. and you will strengthen the whole thing - heat it up with warm air, unless you have done it before. - leave to harden Weight ratio of the flat: 10A: 1B Volume ratio of the mixture: 3A: 1B Shear strength N / mm2: 22-24 Open time: 30 minutes Curing time at 20 ° C: 24h / 20 ° C 80 min / 80 ° C Continuous temperature resistance: - 40 ° C ≤+ 200 ° C Mixture viscosity (mPas): paste Appearance / color: steel Kit for the regeneration of steel tanks: 1. Epoxy adhesive KEMISKIT FE21 30ml / 100g 2. Degreaser for plastics 250 ml 3 Metal etch AP1 5 ml 4. Mixing kit: Plastic pad, 4 application sticks, spatula 5. Metal mesh, rigid No. # 2 12x15