Acralock SA 1-15 NAT polyamide adhesive

Effective plastic glue for polyamides PA - for gluing with each other and other materials How to use: clean the surfaces with the degreaser from the kit, sand the gluing places if possible and remove the filings, apply the AP2 etchant (special for polyamides) and wait about 15 minutes. apply glue and press so that the gap is between 0.1-4 mm. initial setting after only 1 hour. Product features: the adhesive withstands powder coating after gluing filling gaps up to 5 mm (min. 0.3 mm) curing time: 60 min (initial) 24h (full) strength. temperature from -40 to 120 ° C short-term up to 250 ° C resistance to acids, salts and bases expansion up to 75% can be applied to vertical and ceiling surfaces resistant to vibrations and impacts You can also glue: raw metals and powder coated other plastics composites ( not recommended for: glass, stone, untreated wood, polyolefin, rubber with exceptions) Included: 1. Acralock 1-15 NAT glue 50 ml. 2. Mixers / Stirrer - 3 pieces. 3. Etching agent for the surface before gluing AP 2 - 5 ml 4. Degreaser for plastics 100 ml 5. Squeezer for 50 ml cartridges. Available glue packs: 50 ml 400 ml - look for a different configuration Our advice in word, writing and experience is the best of our knowledge, but only non-binding guidelines are relevant, also with regard to any third party property rights and does not exempt you from own samples of the products we provide, in terms of their suitability for specific technologies and purposes. We ensure, of course, the absolute quality of our products according to the general terms of sale and delivery.