ATK 822 car paint primer

Car paint spray primer in a can of 500 ml. It has a special directional nozzle that evenly applies the foundation and does not splash around. By turning the nozzle, the stream can be vertical or horizontal. It is a surface promoter - the primer is colorless and leaves micrometer layers, therefore it does not affect the subsequent varnishing of the surface and does not need to be "taken into account" in subsequent painting activities. Application: under car paints under epoxy, polyurethane, acrylic and other primers, also under putty on the surface: metals, plastics, greasy i.e. polypropylene PP, PP+ T20, PP / EPDM etc. (if you are varnishing polyethylene PE use ATK 823 - pouring it into the spray gun) composites - carbon and glass fiber composites rubber-like plastics TPO, TPE, TEO etc. Instructions: degrease surface (with an alcohol degreaser), do not use solvents, gasoline and other removers, evenly apply the primer to the surface and wait for 10-15 minutes or heating it up for 5 minutes. in special cases, repeat the operation after 5 minutes. (apply twice, especially on absorbent and uneven surfaces). Varnish the element. Note: - the surface must be dust-free and degreased, - application and drying must take place at least above 15 degrees, - if you have not applied this type of primer before the varnish, do some tests beforehand on an unnecessary piece, - the undercoat should be evenly applied without stains, if any (difficult to obtain), sand and repeat the steps.