Description
Dictionaries
Comments
Glue for sticking polycarbonate lamp glasses into the housing. Provides strength and tightness. It is a product that will ensure tightness and strength of the connection between the shade and the housing. If you only need to tighten the shade, because you then twist the whole thing or insert clips - use the modified HYLKOL butyl. Application: gluing reflectors, gluing glasses made of glass and polycarbonate (currently 99%), sealing leaks in complex lamps, gluing reflectors into the housing (if you have a crack, use ATK FIX with ATK FILL). possible (if a layer of old glue remains, which in the future will not stick to ATK812, it will also come off) degrease the surface with a polycarbonate lampshade (99%), coat with P200 primer and wait 20 minutes. the casing made of PP (PP+ T20, PP-TD40 etc.) grease ATK 822 or 8154 in the places where the glue is applied and wait 10-15 minutes. (if the casing is made of PC+ PBT or PBT, instead of 822/8154, put p200) apply the glue carefully and press down on any excess, you can remove it with a spatula, or with a glove, leave the diffuser attached, e.g. with paper tape, for 1-2 hours. for initial bonding or 24h for full If you only want to tighten the lamp because it evaporates, remember to make a leak in the place and after 3-5 cm cut the old glue, making a bevel to which you will apply the glue (remember to press it with a glove or spatula after application to remove any air ). Depending on the material, we use primers as when gluing the entire reflector. Remember - the whole operation should take place in a warm room. If it is below 15 degrees, heat the elements with a heat gun until they reach 20-30 degrees - after gluing, the strength is so high that you have to cut the glue to detach. Included: ATK 812 glue black 400g ATK822 primer (for polypropylene - lamp housing) 500ml spray degreaser alcohol 100 ml
Comments