Car body adhesive ATK EP61

ATK EP61 is an adhesive so strong that we can replace the weld and riveting or support this process, depending on the manufacturer's recommendations for a given car brand. There are spacer balls in the adhesive so that, after application, the joint can be fixed with clamps. The product, as a few, can be bonded with standard welding, i.e. the fender or other part of the body, welded after gluing. Do you need a large package? - go here We glue the following elements: steel fenders and aluminum outer sheathing of the car - steel and aluminum body roof panels - in the case of carbon, use the 1-15 NAT version, thresholds, elements and reinforcements of the front and rear hood, fastening cables, wires, tunnel bundles, etc. also those bolted as additional protection, other reinforcements in the body of the wheel arches How to use / application: Wash and degrease the surfaces with a degreaser on IPA acetone, Sand the surface at the point of gluing and degrease again, Apply the glue so that it spreads to the sides when pressing (you have up to 60 minutes) .) and fix it so that the element does not move, In case of unevenness, you can level them with a thicker layer of glue that seals the whole thing, If you want to rivet, you can do it immediately or wait for the glue to set, If you want to weld, it is advisable to wait until the glue sets, you can sand the glue if it comes out to the sides and then putty and paint. Adhesive version in 2 packages (to choose from) ATK EP61 50 ml+ 2 mixers / stirrers. ATK EP61 190 ml+ 2 mixers / mixers For squeezing large cartridges, a silicone / 300 ml cartridge squeezer is enough, Technical data: Mixing ratio by volume: 2: 1 Mixing ratio by weight: 1.9: 1 Specific gravity g / ml: 1.1 Odor: slight amine odor. Opening time: 60 minutes at 20 degrees. Hand strength: 3-5 hours. (about 1mpa) Color: black Full strength: 24h