Description
Dictionaries
Comments
Gun welding machine with the construction of a heat gun for PVC tarpaulins, banners, tent foils - complete with the necessary nozzles. The equipment is recommended for work with low intensity. Digital display with temperature and blow-out regulation allows you to select the appropriate parameters for the temperature at which we work, thickness and type. Thanks to the display, we can control the temperature and airflow, which significantly improves the comfort of work. If you manufacture or repair service, take the model of the manual Bosite-D or D+ welding machine and the Bosite-Plan machine. For banners and small quantities, you can also use a specialized adhesive with B170 welding power. We do not recommend weak and sticky tapes. Spare tarpaulin patches available here. We combine soft PVC materials, such as: for tarpaulins for banners, for mesh nets for tent foils. PVC protective - rainproof inflatable jump ropes and other air toys such as slides, swimming pools, pools made of thick PVC tarpaulin transparent windows in covers and tents Key Features: handy and light - comfort during work, comfort of use, thanks to the rubber handle on the handle we do not tire our hands during long work, the housing is made of a durable technical material / nylon reinforced with glass fiber / PA+ GF, the display gives us control and regulation of temperature during welding protection preventing the cable from breaking Temperature of tarpaulin welding? On this model, we start at approx. 350-400 degrees with a medium blow. In the case of low temperatures and thick tarpaulins, we raise the air outlet to the maximum and temperatures above 400-450 degrees. In the case of thin banners, we rather stay at 350 degrees. Brief instructions for welding tarpaulins: clean the surfaces around the crack to 3-5 cm around (with a degreaser or pressure washer) if the surface is several years old, gently rub with 300-500 sandpaper to remove loose oxidized pieces and degrease again set the temperature to approx. 350-400 degrees depending on the conditions and the thickness of the material (the colder and the thicker the material, the higher the temperature), heat the edges with pieces so that the patch sticks, insert the nozzle between and press behind the air outlet, remembering not to roll the roller over the nozzles, wait until it cools down and check the durability we obtain when light smoke appears during work The complete set includes: AT4000 welding machine+ 38 mm silicone pressure roller+ 40 mm wide-slot nozzle+ suitcase Technical data: power 2000 W • voltage 230v • temperature display • temperature from 50 to 630 ° C • easy and quick temperature regulation of the device - 1st gear - cooling the device - 2nd gear - Regulation and every 10 ° C - 3rd gear - maximum blow-off with temperature control • blow-out regulation (5 steps) • Japanese MABUCHI engine • 2 m cable Note: The model completely replaced the AT-3500 and AT-4500 models
Comments