Description
Dictionaries
Comments
Welder for welding insulation foils such as: swimming pools, ponds, roofing membranes in a convenient construction, such as a heat gun. It is a model designed for lighter work, however for service welding choose the professional model for continuous work Bosite-D or d+. In the case of PE foil, model 5001 and F1 or 800 will be needed, and Bosite-BX is used for hot-welding. It is a full set with the most necessary accessories for work. In the set you will find, apart from the heater itself, narrowing nozzles on which you attach the 40 mm flat nozzles, to then evenly heat two surfaces and press with a silicone roller that does not stick to the surface and is resistant to temperature. After the surface has cooled down, check with a seam tester whether the material has bonded well with each other - move it slightly pressing and looking for any leakage, if necessary mark such a place and press it further. What kind of insulating foils can we weld? swimming pools (pumped and expansion pools are glued with ATK 812 due to the material being too thin to be welded) roof membranes PVC mesh foils (in case of PE foil use hylkol+ 812) tunnel garden foils - thick transparent PVC variants excluding PE other waterproofing made of polyvinyl chloride or derivatives weldable to roofing papers when heating the surface (recommended: strong 3400W - Bosite-BX) User manual - quick welding training: clean two surfaces by degreasing or with a pressure washer, if possible, make a trial test on an unnecessary piece in order to choose the right one temperature - the best effect, if a light bubble appears, insert the nozzle between the materials and press behind the nozzle, wait until it cools down and check the strength. Included: AT4000 welding machine narrowing nozzle flat nozzle 40 mm silicone pressure roller 38 mm weld tester suitcase Key Features: handy and light - comfort during work ease of use thanks to the rubber handle we do not strain our hands with the handle even during long work hours, housing made of durable technical plastic / nylon reinforced with glass fiber / PA+ GF display that gives us control over temperature regulation during welding protection preventing cable breakage Technical data: power 2000 W • voltage 230v • temperature display • temperature from 50 to 630 ° C • easy and quick temperature adjustment of the device - 1st gear - cooling the device - 2nd gear - Adjustment every 10 ° C - 3rd gear - maximum blowout with temperature control • blowout regulation (5 steps) • Japanese MABUCHI engine • 2 m cable Note: The model completely replaced the AT-3500 and AT-4500
Comments