Description
Dictionaries
Comments
The tape owes its strength to the fact that it is 100% acrylic in full cross-section and not with the carrier (glue-filler-glue), therefore it is so strong and resistant even to UV light. If you do not need transparency, you can use even stronger tape, or increase the x4 strength by sticking it with ATK 812 or PU CLEAR glue. Instructions: degrease the surface with the included degreaser wipe with primer 101 in the places where the tape will be applied and wait 10-15 minutes until it dries, in special cases you can sand the surface lightly, tearing off the protective foil, apply the tape to the surface well (remember not to stretch when applying ) tear off the protective foil from the other side, stick and press the whole thing, 70-80% strength is immediately available, 100% from 1 to several hours depending on the material and gluing temperature The tape is 6 mm wide, if you need to stick a wider piece, stick the tape side by side to create a uniform gluing surface. Remember: the surface must be clean and dry press down well bonding should be done at least 150 degrees, but if it is less, heat the surface with a heat gun, so that it has 20-30 seconds, being careful not to damage the surface. When finished, you can also heat it up slightly so that the heat remains on the surface for some time. Technical data: Thickness: 0.5 mm Width: 6 mm Density: 900 kg / m³ Temperature resistance: 100 ° C Color: transparent Type: double-sided 6mm double-sided tape included. Isopropanol degreaser 250 ml Primer 101 - 5 ml
Comments