Boatbuilding glue - for SA 10-70 boats

Boatbuilding, Marine Adhesive for Yachts and Boats Acralock SA 10-70 See "Important Tips" for the selection of the best adhesive. A special type of Acralock SA 10 HV methacrylate adhesive, which can be joined by the largest elements, thanks to its high expansion it reduces vibrations and impacts, and at the same time, when bonding composite elements, it stiffens the glued structure against torsional forces. The glue itself is light, thanks to which, even at high thickness, the connection is lighter than other epoxy, polyester, etc. adhesives. Easy dispensing from 490 ml cartridges without the need for mixing makes the glue application process very fast. Intended mainly for: - gluing the bottom of boats - sailboats, yachts, motorboats - all kinds of longitudinal and transverse reinforcements - gluing of fixings and cabin hooks Glued materials: composites, laminates etc. plastics (except PP and PE) epoxies, gelcoats, polyesters and styrenes metals (except galvanized ones) Advantages: - does not contain styrene - does not flow from vertical and ceiling surfaces - long time to apply the adhesive - depending on the version from 35 to 120 minutes. - resistant to vibrations, impacts and vibrations (reduces them depending on the thickness) - filling gaps up to 50 mm thick (SA 10-70 - 0.5-30 mm and the version 10-100 - 2-50 mm) - full resistance to weather conditions, as well as salts, non-concentrated acids and bases 3-10 - surface preparation in the case of most materials comes down to degreasing the element - expansion up to 200% (even very large elements made of laminates and metals can be joined without damaging the surface due to vibrations and temperature jumps) - light (1g is 1cm3 - compared to epoxides or putties, the weight of the adhesive and the joined element is significantly reduced), it is easy to calculate the consumption of glue for a given joint The SA 10 HV series includes 6 versions in 490ml cartridges. and 20l buckets and 200l barrels. -SA 10-35 (on order) -SA 10-45 (on order) -SA 10-60 (on order) -SA 10-70 (most commonly used version) -SA 10-100 (on order) -SA 10-120 (ref.) Remember: Glue 1:10 in the cartridge - squeezer needed (the glue cannot be mixed by hand). The set with the glue is one stirrer (mixer). We recommend using 2-3 agitators per one pack of glue. IMPORTANT ADVICE When bonding composites with a laminate: epoxy, polyester, melamine, PS, ES, FRP, CFRP, GFRP, AFRP, BFRP reinforced with glass, carbon, Kevlar and other fibers and textolite with each other and metals, stainless steel, aluminum and plastics in structures We use boats, cabins, railways and santwich spacers: - for small and medium-sized surfaces SA 1 or SA 10-15 BLK - for large and very large surfaces SA 10-70 - gluing and sealing of gelcoats, topcoats etc. with snow color white SA 10-15 WHT - for highly flexible surfaces GB 10-10 - boat sealant - ATK 812 yacht, before you glue even under water - gluing wood-plywood elements with metals, plastics and composites ATK EP61