Glass fiber adhesive SA 1-15

Adhesive for composites of glass fibers and carbon fibers with each other and other materials. The adhesive used by laboratories for testing the strength of composites, because the sample delaminates when breaking. Most often used for: gluing small and medium-sized elements gluing composites with each other, especially metals such as raw steel, stainless steel and aluminum without the use of primers and surface grinding - with other glues gluing composite pipes into aluminum / steel sleeves gluing reinforcements, brackets, angles in automotive, railroad, armaments and renewable technologies. It combines the strength of up to 35 N / mm2 and expansion of up to 75%, which is recommended for bonding metals and composites operating at variable temperatures. If you are gluing elements longer than 1m, the recommended version is Acralock SA 10-15 with an expansion of up to 120%. Also used for: galvanized metals high-gloss stainless steel metals later powder coated DPCD - TELENE (one of the most effective adhesives in the world) polyamides - PA (PA6, PA 66, PA12, PA 11) glass and carbon fiber composites (it is so strong that carbon breaks during tests) raw and coated metals (glues galvanized surfaces without any primers) plastics (also PA polyamides / nylon without primers) composites and laminates RIM - TELENE Technical data color natural working time 15 min (hand strength after 1h. ) hardening time: 60 min (initial) 24h (full) expansion up to 75% gap filling from 0.1 to 5mm resistance to weather conditions, acids, salts, bases (from 3 to 10 ph) resistance to powder coating and galvanization full strength resistant to vibrations and impacts after 6 hours can be applied to vertical and ceiling surfaces - does not run off the surface temperature resistance from -55 to 120 ° C, briefly up to 250 ° C !!! The complete set includes: 1. Glass fiber glue Acralock SA 1-15 NAT - 50 ml 2. Mixers - 3 pieces, 3. Alcohol-based degreaser - 100 ml 4. Squeezer for 50 ml cartridges. 1: 1 IMPORTANT ADVICE When bonding composites with a laminate: epoxy, polyester, melamine, PS, ES, FRP, CFRP, GFRP, AFRP, BFRP reinforced with glass, carbon, Kevlar and other fibers and textolite with each other and metals stainless steel, aluminum and We use plastics in the construction of boats, cabins, railways and santwich spacers: - for small and medium surfaces SA 1 or SA 10-15 BLK - for large and very large surfaces SA 10-70 - gluing and sealing of gelcoats, topcoats, etc. with the color snow white SA 10-15 WHT - for highly flexible surfaces GB 10-10 - boat sealant - yacht ATK 812 before you glue even under water - gluing wood-plywood elements with metals, plastics and composites ATK EP61 Our advice in the word, to the best of our knowledge, however, are only valid in writing and through experience, but are only relevant for non-binding guidelines, also with regard to any third party property rights, and do not exempt you and from our own tests of the products we provide, in terms of their suitability for specific technologies and purposes. We ensure, of course, the absolute quality of our products according to the general terms of sale and delivery.