Knife for cutting sponge and foam D3

The RNTR D3 thermal knife with a top is an ideal device for cutting and cutting sponges. A wide and smooth adjustment range enables trouble-free adjustment of the temperature to the material being cut without the risk of burning it. The very thin wire ensures high cutting accuracy and clean edges. In addition, you can set it at the desired angle, depending on your needs. It only takes a few seconds from turning on the D3 Thermal Knife to start working and cut the sponge or foam. The special design allows for the winding of more wire, so when it is broken, it can be quickly replaced with a new one. A guide bar with a wide range of adjustment allows for precise marking of the cutting line, and an additional attachment allows for cutting in a circle. The thermal knife with the D3 table top saves time, ensures high precision and high speed of work. The power supply is protected against overheating. Cutting surfaces along straight lines: along and across, at an angle and an attachment for cutting circles, semi-circles and other shapes without additional guides installed (see the movie). If you want to manually cut polyurethane foam or other foam, choose the manual model of the AT-100 thermal knife Advantages: wide temperature range adjustment, power supply with voltage regulation - allows you to adjust the work to a given material, the ability to set the device at the desired angle, high cutting precision, an additional attachment allows you to cut in a circle. Application for cutting: polystyrene, styrodur, polyethylene foams, polyurethane foams, plastics. Technical data: Power: up to 96W Voltage: 12V-24V Temperature - 0 to 550 ° C Dimensions: 400 * 600 mm Weight: 4.8 kg Cable: 2.30 m Also available on request: power 30W, table top 40 x 80 cm, blade length 330 mm (other dimensions of the tabletop available on request.The arm can be tilted at an angle of 90 ° to 30 °