Description
Dictionaries
Comments
Mounting adhesive for plastics and metals Acralock 1-15 The advantage of this mounting adhesive is a very high bond strength - greater than the strength of plastics and the average time for application, i.e. 12-15 minutes, we have to apply as needed and fit the surfaces as needed - we don't have to rush that the glue will dry in a moment. Once cured, the adhesive is water-resistant, as well as gasoline and household chemicals. We can use it to connect 2 different materials with each other and with metals, such as steel, stainless steel, and even high gloss, as well as galvanized connectors and screws. List of materials that can be combined: ABS PC PA PVC foamed PS PS Not suitable for gluing PP and PE - if such plastic is to be glued, choose the ACRALOCK PP 1-02 variety. Technical data natural color working time 15 min (manual strength after 1 hour) curing time: 60 min (initial) 24h (full) expansion up to 75% gap filling from 0.1 to 5mm resistance to weather conditions, acids, salts, alkalis ( from 3 to 10 ph) resistance to powder coating and galvanization full strength after 6 hours resistant to vibrations and impacts can be applied to vertical and ceiling surfaces - does not flow from the surface temperature resistance from -55 to 120 ° C, short-term up to 250 ° C !!! The complete set includes: Acralock glue 1-15 NAT - 50 ml Economical squeezer 1: 1, 2: 1 3 mixers, stirrers for squeezing the glue Degreaser based on isopropanol 100 ml. You will find larger 400 ml cartridges on other configurations. Our advice, in words, in writing and through experience, is the best of our knowledge, but only non-binding guidelines are relevant, also with regard to any third party property rights, and does not exempt you from your own trials of the products we supply with regard to their suitability for certain technology and goals. We ensure, of course, the absolute quality of our products according to the general terms of sale and delivery.
Comments