Heater for shrink film AT-4000

Heater for heat-shrinkable films with a heat gun structure with temperature control. The manual construction with a rubber handle allows you to comfortably hold the equipment even in hard-to-reach places. Regulation of blow-off and temperature allows for precise selection of parameters depending on the work performed, and a large number of optional nozzles further increase these possibilities. It has a cooling gear that allows you to easily and safely turn off the device in order to extend the life of the heater. The equipment works great both at home and in the workshop for less intensive work. For continuous work, choose the BOSITE-D model. What works can we use for? as a heat gun for wrapping cars, i.e. car foil - car wrapping, shrinking heat-shrinkable foil, applying thermo shirts - even very small ones, which is facilitated by a 9 mm tapering nozzle in the set) plastic molding (we recommend a 40 mm flat nozzle for precise works) - also at home burning paint and wood (flat nozzle or wide-slot nozzle 70 mm) bending plastics heating defrosting - defrosting soft soldering (reflector nozzle is enough) welding tarpaulins, banners, insulating foils etc. (it is enough to buy a 40 mm flat nozzle and a pressure roller) remove old paint coatings , adhesives, sticker What do you get? Heat gun for AT-4000 foil+ case+ 2 nozzles (BUT+ reduction 9mm) Technical data: power 2000 W • voltage 230v • temperature display • temperature from 50 to 630 ° C • easy and quick temperature control of the device - 1st gear - cooling the device - 2nd gear - Adjustable every 10 ° C - 3rd gear - maximum blow-off with temperature control • blow-out regulation (5 stages) • Japanese MABUCHI engine • 2 m cable Key Features: handy and light - comfortable during work, comfortable to use, thanks to the rubber handle with the handle does not tire your hands even during long work casing made of durable technical plastic / nylon reinforced with glass fiber / PA+ GF display that gives us control over temperature regulation during welding protection that prevents the cable from breaking Remember: after switching on and setting the operating parameters, wait 30s-1min for the whole the heaters have warmed up and the temperature has stabilized do not use nozzles other than those provided by the manufacturer do not block the entire inlet neither here nor the air outlet, periodically clean the air inlets from dust, in order to turn it off, always turn on the 1st gear, so that the entire heater has cooled down for 1-2 minutes - only then turn it off completely. Note: The model completely replaced the AT-3500 and AT-4500