High-temperature adhesive ATK 663

High-temperature adhesive for glass-metal-plastic and rubbers ATK 663 If you need to bond metal to metal, use Kemiskit FE21, or if you are gluing fireplace elements with direct focus on fire, use ATK FIRE. It can be used for bonding two surfaces, sealing existing joints or sealing old gaskets or replacing them completely. As a gasket, it can be used on the principle of overlapping and twisting, target or initial light tightening to obtain 0.5-1 mm thickness, and after setting, tightening the whole. Application: oven panes - gluing the glass to the guides instead of / or as a supplement to the original gasket; sticking the door to the metal frame; fixing the gasket sealing the chimney ducts sealing heat exchangers sealing steel hot water tanks, especially on leaking heater seals, etc. bonding silicone gaskets of various origins - automotive, household appliances, industrial Bonded materials: glass, metal, plastic (we recommend performing tests for adhesion, whether or not you need a primer such as e.g. P200) ordinary and silicone rubbers, other - eg stone, wood Technical data 250 ° C, short-term strength 300 ° C, peak strength up to 1h. 350 ° C retains flexibility at low and high temperatures initial hardening time 20-30 min. full - 24-72h. Depending on air access, humidity and thickness, recommended adhesive thickness: min. 1 mm. high chemical resistance: e.g. sodium carbonate 24%; hydrochloric acid 2%, soda solution 20%, bleaching agents common in use hardness (shore): 20 Color: White Remember: the surface should be clean; it is best to rinse with an alcohol-based degreaser (bought in our store) or acetone. glass and metal surfaces glued below 15 degrees should be heated so as to remove residual moisture, with some plastics it may be necessary to use an ATK 822 or P200 primer.